Well already messed up on wire but Indy was able to get it out and fix for me. Now I'm working on the other connectors. All the wires released but 3 and no matter what I try they are stuck. I have the white part pulled out 1/4" and the rear of the plug is removed. I'm using a mini screw driver flat head that's micro size and fits in hole. Do I need to remove the blade of the screw driver and make it where it's just the round shaft?

 

Round works best. I took a mini screwdriver and ground the edges down to make it round and it works like a charm. Paper clips, when sturdy and properly used work well too.

 

It's like the screwdriver is just going in too far and bypassing the release mechanism

 

I used a large paper clip. What connector are you talking about exactly? Do you search you tube? That ha help me a lot with connectors.

 

paper clip

 

Just did my handlebars they were wired internally to begin with. Used a paper clip worked like a charm!

 

$2.50 on Amazon, it works like a charm.
Delphi Packard Weatherpack Terminal Release Tool

Performance Plus Connections

 

So does a paper clip lol

 

I've used a paper clip put found a sewing needle works even better.

 

I have a large safety-pin in my toolbox for releasing wire clips. Ground off the point and it's much stronger than a paper clip (doesn't bend). Never lets me down...