This weekend I installed a Wards Parts Werks FCS cooling fans on the ol RK. It is combined mounting with a Howards hog horn so I took a few pictures for anyone considering the same install. Quality of the fans is excellent BTW.

pic 1 Howards hog horn (before)

pic 2 remove compressor

pic 3 modify horn mounting bracket by extending notch 1/2 inch deeper

pic 4 remount bracket in new notch

pic 5 mount fan assembly and level

 

pic 6 tighten it down https://www.hdforums.com/forum/attac...1&d=1363142661

pic 7 switch for fans https://www.hdforums.com/forum/attac...1&d=1363142661

pic 8 clean up wiring https://www.hdforums.com/forum/attac...1&d=1363142661

pic 9 install complete https://www.hdforums.com/forum/attac...1&d=1363142661

 

Excellent job,now I would like to see the install of the cooling fans while retaining the ProPad football horn.Thanks

 

Peekayphx, great job on the combined install with Howards horns, many folks are interested in a similar set up.
Lusian, I have a mount solution for the MB horns, the football cover style will visually shroud the fans a bit, but it doesn't have a negative impact on cooling performance.

 

Just installed mine with thermal switch. Static test passed with flying colors.

 

Do they whistle Dixie

 

"I want one of these systems". Just got to figure out where to get the money.

 

Just installed mine a couple of days ago. Went on a 755 mile ride through SE Ohio. Rode the OH-555 (Triple Nickel) and my oil temps never exceeded 235*. Works fantastic and great workmanship. My concern here is is there too much weight hanging from the one vibration isolator mount bolt and did you maintain a minimum 1/4" clearance from the cylinders as specified in the installation instructions?

 

I wish they had a set for our hard hats. I did make sure to have enough distance from motor .