from there is is rather simple...just need to mark locations/placement of wires..want male and female sides to match....there are only 3 wires ..the orange wedge holds the place...just make 100% sure you match same colors on male to female side...\
Requires no special tools, no special wrenches, no soldiering....
unfortunately i do not know how to test the entire plate system..I do know that melting is bad and that the tilt or vehicle attitude sensor is inside the plastic part of plate..
The tilt/attitude sensor in cam plate(melted part) cuts out spark and hence shuts motor if bike falls on its side...supposedly you could test off the bike for continuity by picking the correct two wires and tilting plate back and forth...
but again melting is bad..
need more info. let us know.
|