call me a rook. ive already taken a lot of things apart on my bike and changed parts around. but for some reason im drawing a blank on how to disassemble my turn signals so that i can send the wiring through my bars. really, i dont want to screw up my chrome by jacking around and not doing it right.

anyone got any help?

 

are they the bullet lights? If so, :

Use a nickel to pop off the lense
remove bulb
use a coat hanger hook to grab the small opening towards the inside bottom where bulb goes
gently pull, should pull out the reflector and rubber gasket
Twist wiring form backside to pull through connector
reverse to reassemble

 

Check the ape install thread for turn signal info. https://www.hdforums.com/forum/dyna-...e-install.html

 

awesome thanks a lot guys! and im sorry for the lack of simple knowledge on the subject. im finishing my apes tomorrow night. i have to run the wiring and put the clutch cable on. everything else was a breeze! except i did have a little mishap with gas spilling everwhere... i was use to a carbuerated bike. but i got it under control! thanks again fellas!

 

http://s667.photobucket.com/albums/vv40/OhioSkully/

Here are some pics of what everyone is talking about this will show you the insides and what your taking apart i took these one of the times i took mine apart

 

That's the most important aspect of the site. To help fellow riders in need! Really glad you got help! Hope I do if I need it!
I'm sure I will.

 

Found this thread from the search feature. Gotta love it, my blinkers are of to get powdercoated tommorrow!

 

I need to take mine apart and this was a great help

...this proves the search button is not broken

 

Subscribed to thread for reference.
Doing internal wiring in a few weeks.
Cheers,

Tom