Carb and VOES
#1
Carb and VOES
The motor I am looking at buying comes with a S&S Super G carb and manifold installed. They test run and time the engines before shipment. My tank is an aftermarket one piece smooth tank. My question is this, I am not going to be using the HD petcock on this bike. I will most probably be using a Pingle or similar. I am guessing I just have to have the vacuum line on the carb plugged to use this. I want to avoid the VOES system and Pingle says it is not needed with their petcocks. Anyone ever do this and cap off the VOES system?
#3
Pardon my ignorant question, but what else is connected to the VOES? This bike will NOT have a stock Harley wiring harness as it is being built from the ground up. It will most probably be using the Ultima wiring harness where everything is consolidated into one small box. The wiring schematic for this harness does not show a VOES switch.
Last edited by cwhite6; 03-14-2011 at 04:56 PM.
#4
Most aftermarket ign systems, Dyna, Ultima, give you the option of using the V.O.E.S. or selecting an advance curve that provides advance built in. As far as the stock petcock, it uses vacum from the V.O.E.S. to operate, but you can use an aftermarket petcock, plug the vac. line and the V.O.E.S. will still funtion.
#6
Join Date: Sep 2007
Location: Bluffton, South Carolina
Posts: 4,468
Likes: 0
Received 10 Likes
on
10 Posts
The VOES can help prevent detonation and doesn't really hurt street performance. It is cheap insurance for your engine with the direction todays fuels are going. There are two wires on the VOES switch, one goes to the wire from the ignition, the other goes to ground. Set the vacuum switch to 7 inches of vacuum and you should be fine. Hope this helps.
#7
The VOES can help prevent detonation and doesn't really hurt street performance. It is cheap insurance for your engine with the direction todays fuels are going. There are two wires on the VOES switch, one goes to the wire from the ignition, the other goes to ground. Set the vacuum switch to 7 inches of vacuum and you should be fine. Hope this helps.
Trending Topics
#8
Confused
Just following this thread I have a 1994 Road king, I have been messing with the carb. The previous owner had capped the voes near the petcock and installed a golan (similar to pingel) but left the voes connected on the carb. Recently I took apart the carb apart and put a plug on the voes connection on the carb. Unplugged the voes and stripped the entire thing from the top motor mount. I figured the Voes had allready been disconnected from the petcock and capping at the carb shouldnt change anything????
Is this ok?
Thanks
Is this ok?
Thanks
#10
As stated VOES controls the ignition advance. The connection to the fuel petcock is because the older style petcocks were vacuum operated if there was no vacuum there was no fuel. It was a early attempt at an automatic petcock but caused major flooding of the engine when the vacuum seal failed.
If your running an aftermarket ignition you can set most to accept the VOES input or to use one of the canned advance curves without it. I will be using it on my EVO build as a safety measure.
If your running an aftermarket ignition you can set most to accept the VOES input or to use one of the canned advance curves without it. I will be using it on my EVO build as a safety measure.