I am running a Mallory distributor on my 48 pan. Saturday night the cover screws vibrated out and the cover came loose. One of the wires was broken. I fixed the wire but I think the module is also bad now. The bike will fire but it won't run. I was wondering if any of you might know where I can find a replacement module. The part number on the one I have is 6001M.

Thanks,
Woolly

 

I have not used the mallory-



but if you need a replacement sensor unit ( 12 and 6 volt) inside the stock points cover:

http://www.ebeyond2000.net/quickstart.html

which I use on my '53.

It is flawless and worth every penny.

Mike

 

Here is the address an phone for Mallory....might give them a call

550 MALLORY WAY, CARSON CITY, NEVADA 89701 (702) 882-6600

 

Does it look like this? http://www.jegs.com/i/Mallory/650/61...FQUZQgodzXXn0A

 

i called them today, the 6001m is just a stock#, i told them i had a e spark 6001m for harley 73 flh, he told me the part # is really 8554 and sent me the diagram for it.

 

I tried mallory but they don't sell direct. They did say autozone should be able to get it for me. Going to try them tomorrow. If not I will give jegs a call. Thanks for the help.

 

Napa carries Mallory via Balkamp too. http://www.napaprolink.com/results.a...word&Nty=1&N=0

 

I contacted Mallory again. They told me the part number was now A605. I then tried autozone but no luck. I ended up ordering off Mallory's website. $102 total. I hope this takes care of the problem. I tried to start her today and its still doing the same thing. It will fire and thats it.

 

How did this play out for you???

 

Worked out great! I still have it on the bike and working fine.