Removing the ends on RZ4 and a few other pre purchase ?s
#11
And yes sir, you will want to adjust your gain for front, separate from gain for the rear. When they start distorting, back it down a notch or two.
#12
Kris, take a few minute in preparation to solder/tin the ends of the wires that will screw down into those terminals. This gives the screw something solid to bite into otherwise you're liable to find yourself pulling the fairing cap and reconnecting wires after your install.
And yes sir, you will want to adjust your gain for front, separate from gain for the rear. When they start distorting, back it down a notch or two.
And yes sir, you will want to adjust your gain for front, separate from gain for the rear. When they start distorting, back it down a notch or two.
Kris
Thread
Thread Starter
Forum
Replies
Last Post
Texas Rapier
Audio Systems
7
09-18-2016 03:28 PM
Shadowbennie
Audio Systems
5
03-09-2015 09:17 AM
GasCan
Electrical/Lighting/Alarm
82
08-12-2012 02:41 PM
GasCan
Electrical/Lighting/Alarm
29
03-19-2011 06:37 AM