Bent CVP EZ-Just screw needle
#1
Bent CVP EZ-Just screw needle
Hi everyone, what do you think of my bent CVP EZ-Just screw needle?
I rebuilt my carb yesterday and went for a spin to warm it up before setting my idle and mixture screws. As I pulled back into the garage it won't idle.
A moment later I see the EZ-Just screw laying on the floor and found the spring, washer, and o-ring sitting on the engine case. I'm lucky to not have lost it. Next time I'll use thread tape to stiffen it up and maybe a gob of silicon to act as a lock on the outside.
Anyhow, now the needle is bent, either from seating it, it falling, or perhaps me stepping on it.
Do you think it'll be ok if I can straighten it without damaging? Other thoughts?
Thanks.
I rebuilt my carb yesterday and went for a spin to warm it up before setting my idle and mixture screws. As I pulled back into the garage it won't idle.
A moment later I see the EZ-Just screw laying on the floor and found the spring, washer, and o-ring sitting on the engine case. I'm lucky to not have lost it. Next time I'll use thread tape to stiffen it up and maybe a gob of silicon to act as a lock on the outside.
Anyhow, now the needle is bent, either from seating it, it falling, or perhaps me stepping on it.
Do you think it'll be ok if I can straighten it without damaging? Other thoughts?
Thanks.
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post