CV Float Pin Size?
#1
CV Float Pin Size?
i am getting ready to buy a punch/chisel set. maybe the dasco set below.
does any one know the size of a float pin in a cv carb? are there different pin sizes through the years?
after some research, looks like the 1/16 (1.7mm) punch might be small enough.
willing to bet it will take a 1/32 punch though.
thanks
does any one know the size of a float pin in a cv carb? are there different pin sizes through the years?
after some research, looks like the 1/16 (1.7mm) punch might be small enough.
willing to bet it will take a 1/32 punch though.
thanks
#2
Thread
Thread Starter
Forum
Replies
Last Post