And hey! Donīt put on the belt guards! Looks better without!

 

Where does the spacer go ?? I assume on the axle, but where and does it re-align the rear pulley or something??

 

There are two spacers, on on each side of the wheel. Between the bearing and the swingarm. (The brake caliper works as a spacer as well).

My new wheel had a wider hub, so I had to take off half inch on the left spacer to make it fit right.

 

I should have said this earlier but my excitement got the best of me. This would not have been possible without bosken's amazing work and input along the way, his bike was a inspiration. So bosken you rock and thanks for all the input and suggestions.

 

What dealer did it? I'd like to visit them and see if they can do it to my 07 wide glide. I have the profile laced rim with the SE 180 on it now. Thanks

 

07fxdwg, stealers around here wouldn't do anything like this...
I am sure imjdoggie will respond, but I think he took it here...

http://www.jtcustomdesign.com/

 

^^^^^07fxdwg, Goddahavit hit the nail right on the head, that is where I took it. I'm sure they can do this to any bike, they do some amazing work.

 

Bosken...are those the Roland Sands bars you have on your bike? You like those? Are those 12 inch bars?

 

imjdoggie what bars are you running? Are those Nightster bars?

 

I think they are the nightster bars, I'll find out for sure tomorrow. I'm still not sure if I want to cut the fender struts off yet I'm sure they will be off sooner or later but I just don't have the ***** to do it now. Here are a few mock setups tell me what you think.