V&H FP3 Issues
#1
V&H FP3 Issues
So, I just got my bike back from dealer for 5K service. Anyway, I had a couple of minor warranty things taken care of before my warranty is done. Since I picked it up, I notice it doesn't start quite as easy as it did. So I went to auto tune my FP3 and get an error message when it tries to flash in the tune. It shows my different tunes including my latest auto tune as current, but when I go to do auto tune, I select what tune as base, it goes to grid screen, the tries to flash. During the flash, it stops and gives an error code. Last time the FP3 acted up, there was an update available for it and that solved it. This time, it's up to date. Any ideas?
On a different subject, this issue has me thinking about going with the power vision. If I did, I'd get it from Fuel Moto. My question is will it run any better? Can that be used to dyne tune down the road?
On a different subject, this issue has me thinking about going with the power vision. If I did, I'd get it from Fuel Moto. My question is will it run any better? Can that be used to dyne tune down the road?
#2
Join Date: Jan 2007
Location: along the shore of Mishigami
Posts: 15,674
Received 4,294 Likes
on
2,352 Posts
#3
that's what it sounds like to me and same suggestion I would make to start as if you just bought it.. not the first time a dealer has overflashed a custom tune
#4
Thread
Thread Starter
Forum
Replies
Last Post
matthbert5150
Ignition/Tuner/ECM/Fuel Injection
10
05-30-2018 09:23 PM