Quick Question: Installing Mid Controls (switching from Forward Controls)
#1
Quick Question: Installing Mid Controls (switching from Forward Controls)
I bought my 07 FXDB with forward controls pre-installed by the dealer. Just decided that I want to reinstall the mids. Right now, the hole in the primary cover has a cap in it (where the mid controls shifter shaft will go through.) On a Dyna with the stock mid control, is there any kind of seal/bushing for that hole? The service manual is a little vague in this area.
I have the shift lever, minus some hardware but I do want to do the job right.
I have the shift lever, minus some hardware but I do want to do the job right.
#2
I bought my 07 FXDB with forward controls pre-installed by the dealer. Just decided that I want to reinstall the mids. Right now, the hole in the primary cover has a cap in it (where the mid controls shifter shaft will go through.) On a Dyna with the stock mid control, is there any kind of seal/bushing for that hole? The service manual is a little vague in this area.
I have the shift lever, minus some hardware but I do want to do the job right.
I have the shift lever, minus some hardware but I do want to do the job right.
.
this is from the parts manual - the seal is # 22..............
.
.
.
.
.
.
.
.
#4
#5
#6
#7
There is no seal that goes on the shifter arm. It just slides thru the inner and outer primary covers. The #22 gasket is what keeps the primary oil from leaking out thru the shifter hole in the primary. It is probably actually still in between the two primaries on your bike but it doesn't hurt to install a new one.
Trending Topics
#9
Thread
Thread Starter
Forum
Replies
Last Post
rogersachs
Dyna Glide Models
5
10-03-2014 12:38 AM