Q: 2006 Wide Glide Turn Signal Sense Wiring
#1
Q: 2006 Wide Glide Turn Signal Sense Wiring
The previous owner changed the front turn signal units.
When he did it, he didn't realize that the extra blue wire was for computer sensing and he didn't reconnect those wires.
Now I am getting codes that the trun signal sensor is not working.
Can someone tell me:
Does the sense wire connect to the hot turn signal wire or does it connect to the return (ground) wire.
Thanks,
Bob Nisbet
Sr Technology Protection Engineer
Army Research & Technology Protection Center
Redstone Arsenal, AL 35898
Office: 256-876-1939
Cell: 256-797-4152
When he did it, he didn't realize that the extra blue wire was for computer sensing and he didn't reconnect those wires.
Now I am getting codes that the trun signal sensor is not working.
Can someone tell me:
Does the sense wire connect to the hot turn signal wire or does it connect to the return (ground) wire.
Thanks,
Bob Nisbet
Sr Technology Protection Engineer
Army Research & Technology Protection Center
Redstone Arsenal, AL 35898
Office: 256-876-1939
Cell: 256-797-4152
#3
#4
Unless they made a change from 05 to 06, which I have not found to be the case on wiring, the blue wire on the rear lights is the running light, just as it is on the front.
Here is a simplified wiring diagram I made. The sensor for auto cancel is in the speed sensor, it senses change in speed to cancel the signals from what I have been able to figure out. Found this when I went to the digital gauge, auto cancel did not work without the speed sensor wire connection from the ECM.
Here is a simplified wiring diagram I made. The sensor for auto cancel is in the speed sensor, it senses change in speed to cancel the signals from what I have been able to figure out. Found this when I went to the digital gauge, auto cancel did not work without the speed sensor wire connection from the ECM.
Thread
Thread Starter
Forum
Replies
Last Post
Gnassty
Ignition/Tuner/ECM/Fuel Injection
5
08-28-2023 09:49 PM