Hey all, my bike just shut down at slow speed this morning and
at work got a P0131 code.
I was able to restart right away but shutting down in trafic is not good.
Any Ideas?

 

Hi...take a look and see if any of this information helps you.
https://www.hdforums.com/forum/softa...le-causes.html

 

Front Oxygen Sensor Low

 

That code possibly has been set by your Xied's,probally not related.
You may want to check your system relay inside your electrical center,it's either gray or black-can't remember which,the other one is the starter relay.

My bike was stalling and dying too, and after a couple of rounds with the dealer(still under warranty at the time) I had to track it down and fix it myself.
I actually pulled the relay apart and it was full of green corrosion.Installed a new one and never another problem.
Check it out you may have the same thing going on.

 

Made it home OK, didn't need to get stuck in a tornado, not far away. Springfield Ma. on the river. hailed.
well after reading this I am going to check for exaust leaks, check the system relay.
I cleared the codes before I left for home.
I might add that the other day I pushed the bike hard and the day after it started.

 

I've been running xieds for two years,po131/151 has always shown up in the codes(front&rear sensor low/lean)this is very common,the bike runs perfectly.Don't forget to check your battery cables and make sure they are tight.

 

OK thanks for the imput on the Xieds, I thought they had them code errors straightened out.
I had new spare relays so I changed them anyway. Tightend the exaust at heads at bit.
The thing that bothered me is my bike had shut down briefly but I was able to just restart it.
Well after a little ride tonight the bike is fine.
Thanks for your help.