Street Bob wont start after Fuelpak install
#1
Street Bob wont start after Fuelpak install
Today I installed some Vance and Hines Short Shots Staggered, a naked VO2 Intake and the Fuelpak to map my ECM.
After installing the Fuelpak my bike wont start. It cranks all right but it wont fire up. It's like its not getting any fuel. However when I remove the Fuelpak it fires right up.
I called the help line at Vance and Hines and we both verified that it was hooked up and programed correctly. The tech was stumped too, but he said that it might just be a loose connection and is sending some wire clips to see if that is the problem.
Has anyone had similar problems with the V&H Fuelpak?
After installing the Fuelpak my bike wont start. It cranks all right but it wont fire up. It's like its not getting any fuel. However when I remove the Fuelpak it fires right up.
I called the help line at Vance and Hines and we both verified that it was hooked up and programed correctly. The tech was stumped too, but he said that it might just be a loose connection and is sending some wire clips to see if that is the problem.
Has anyone had similar problems with the V&H Fuelpak?
#3
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post