Handlebar swap succesful, almost
#1
Handlebar swap succesful, almost
What a pain, took a few hours. Only thing i had a problem with was pulling the wiring through the new bars. They had really sharp 90 degree angles that made it a b*tch. A pin in the left molex connector broke, and now my front left blinker does not work. Anyone know where i can get a new pin? Or what kind they are so i can order online?
#4
#5
#7
I broke a pin as well. I got some connectors from the dealer but didn't have the special crimper for them. I just used an insulated butt splice. Much simpler and faster, if you have the crimp tool for them. Also, I believe the smaller turn signal connector used different terminals than the big molex connector on my bike. I have a 2010 Street Bob
Last edited by Cloyder; 08-27-2012 at 08:21 AM.
Trending Topics
#9
Join Date: Feb 2007
Location: Harmelen (The Netherlands, Europe)
Posts: 8,986
Received 867 Likes
on
576 Posts
What a pain, took a few hours. Only thing i had a problem with was pulling the wiring through the new bars. They had really sharp 90 degree angles that made it a b*tch. A pin in the left molex connector broke, and now my front left blinker does not work. Anyone know where i can get a new pin? Or what kind they are so i can order online?
Thread
Thread Starter
Forum
Replies
Last Post