I have my tank off and replaced my triple trees. I have reconnected the turn signals on both side and the left and right bundles that come through the trees. Now I have the connectors that go to the dash and tank sorted out, but can't identify this one here:



Its a four wire with flat blades inside the connector. The wires are solid red, white, yellow, and black.



I just want to know if I need to fish for its mate up in the neck or if it is somewhere on the tank or dash that I missed. Thanks for any help.

 

If that wire is orange/white and not red could be head light.

 

OR/Wh is usually accessory power. White, Yellow and Black usually go to the headlight.

Check your fuel pump/gauge, other than those not sure what that would go to up front.

 

Looks like the connector for the headlight to me !

 

100% sure it's the connector for the head light harness

 

Rule #1. Always tag cables before pulling them apart.

Look for a plug that has the same dimensions and same number of sockets and see if they fit together.

Better yet. Put the cable down and take a photo of the whole cable. From were it starts and finishes. And a photo of what plugs you have left over that's not connected. Post them and let us have a look.

 

Easier: turn the bike on and see what doesnt work....

 

Instead of tagging and photographing, which is not a bad idea... Get the wiring diagrams, if you don't have a service manual, which includes them, try this link that Rene was good enough to post for everyone.

https://www.hdforums.com/forum/dyna-...-part-1-a.html

 

That's where I found the answer to OP's question, Rich!

 

I am just surprised I beat you to it... I picked it out of the old dead brain cells...