anyone do this? Going to get the SE disc pack and SE Heavy duty spring tomorrow. Is it pretty straightforward? According to SM. it doesn't look too hard. Any suggestions or tips?

 

would I get any comments if I asked, "Is the SE clutch pack, a girls clutch pack"? Can't believe I get no input.

 

I think nobody is responding cuz its a clutch install.

start with fiber, then metals, end with fiber......Install pressure plate and then spring.

I use the SE clutch spring ONLY on my bikes on stock clutch pack. If I were to go any further with upgrades I would use the Barnett Scorpion clutch with coil springs rather than the diaphragm spring.

That being said I have been extremely happy with the SE clutch spring on stock clutch plates and found no need for upgrading any further.

 

That's my experience. Changing clutch plates is pretty easy. Just take your time.

 

And make sure you soak the friction disks before install. Easy job.