Replaced bars. Now when I apply rear brake my right turn signal comes on.
And when activate right signal brake light comes on.
Need a little in site on which wires I got messed up.
Everything else works fine. Thanks in advance.
Replaced bars. Now when I apply rear brake my right turn signal comes on.
And when activate right signal brake light comes on.
Need a little in site on which wires I got messed up.
Everything else works fine. Thanks in advance.
Open the right handlebar switch housing. Sounds like you've switched the brake light and right turn signal.
On my 2010 FLHRC the right turn is orange/white and the brake is Red/Yellow. Yours is most likely the same.
Everything looks correct. When I apply rear brake everything good. When I apply front brake no light. When I apply both simultaneously right indicater comes on.
As far as think a bout it. I've been wrenching on these things since I was 15. Believe me I've thought about it. This one has me stumped. I'm not perfect. I'm probably over looking somthing.
Nothing. I pulled the pins out of the connectors on each side under the tank. Pulled the wires out of stock bars. No splicing was needed. Ran the wires inside new bars installed pins in connectors. Plugged in.
Post 5 is Excactly what is happening now. When I apply front brake the light does not come on. When I apply rear brake the light comes on. When I apply both front and rear at the same time my right signal comes on??