Turn Signal Wiring
#1
Turn Signal Wiring
Hello All!!
I am seeking help with the wiring connectors for my 2013 Street Glide. I am attempting to take a ton of parts off the bike to have them powder coated black instead of buying new black parts and have run into a little snag. It seems as the the wires dont want to come out of the connecter so that i can feed them through and remove them from the housing. I dont want to just grip and rip and possibly do some damage, so does anyone know a trick or am I just being a sally about pulling the wires out??
Thanks in advance to all the helpful people on this site!!
I am seeking help with the wiring connectors for my 2013 Street Glide. I am attempting to take a ton of parts off the bike to have them powder coated black instead of buying new black parts and have run into a little snag. It seems as the the wires dont want to come out of the connecter so that i can feed them through and remove them from the housing. I dont want to just grip and rip and possibly do some damage, so does anyone know a trick or am I just being a sally about pulling the wires out??
Thanks in advance to all the helpful people on this site!!
#2
Don`t try yanking the wires out of the connectors.
You need an extractor tool to remove the wires. There are different types depending on the type connectors your bike has. I think your bike has Molex MX 150 connectors, which use a straight metal pin to remove the wire/connector from the plastic housing.
You need an extractor tool to remove the wires. There are different types depending on the type connectors your bike has. I think your bike has Molex MX 150 connectors, which use a straight metal pin to remove the wire/connector from the plastic housing.
Thread
Thread Starter
Forum
Replies
Last Post
ckamin
Ignition/Tuner/ECM/Fuel Injection
2
06-05-2006 02:06 PM