Brake/Run/Turn Signal Kit Not working
#1
Brake/Run/Turn Signal Kit Not working
My bike is a 2009 Ultra Classic, kit for this is #69461-06D. Plugging it in to my harness going to rear turn signals and tail-light, per instructions, results in NO CHANGE. I am supposed to get running lights and turn signals operating as brake lights as well, etc., .....nope. Why?
Thanks for any ideas you have about this........
Thanks for any ideas you have about this........
#3
Thanks.
#4
I found the problem. I installed LED turn signal bulbs front and back several weeks ago. I removed the rear bulbs and replaced the original bulbs thinking the run/brake/turn kit would only be affected by the rear turn signals. Well, not so. After removing the front turn LED's and replacing with the original bulbs the run/brake/turn kit works just fine. I've searched for a stabilizer that might allow me to use LED's with this Harley kit. Custom Dynamics claims to have such an item which I might try someday......just another $75.00......gone with the wind.
Thread
Thread Starter
Forum
Replies
Last Post
Rossi
Touring Models
4
04-03-2011 06:08 PM
capt42a
Ignition/Tuner/ECM/Fuel Injection
3
11-02-2005 01:29 PM