Looking for suggestions on possible cam swap
#1
Looking for suggestions on possible cam swap
I have an 05 Ultra with 143k and I've been running 95in, stock heads, V&H propipe, SE air cleaner, SERT and 510 gear drive cams for the last 110k. I just installed SE CNC ported heads and I was wondering if there was a better cam to run with my new engine configuration. I do a lot of highway miles , and my RPMs are between 2500-3200. Any suggestions are welcome. Thanks.
#2
i have an 05 ultra with 143k and i've been running 95in, stock heads, v&h propipe, se air cleaner, sert and 510 gear drive cams for the last 110k. I just installed se cnc ported heads and i was wondering if there was a better cam to run with my new engine configuration. I do a lot of highway miles , and my rpms are between 2500-3200. Any suggestions are welcome. Thanks.
#4
#5
#6
whats the cc on your heads something isnt right also are you running dome pistons or flat tops or you must have 9.8:1 corected without your cam chioce if so tman 555 torqster would leave you 9.1 corrected 190 ccp
Last edited by jurgie; 05-30-2016 at 08:17 AM.
#7
Trending Topics
#8
Good, you found the bust. You need a cam with a very early intake close like the S&S 551 or 583 to get CCP up near 190psi......
Last edited by djl; 05-30-2016 at 11:30 AM.
#10
FYI, SE CNC ported heads have the same chamber volume as your stock heads. Couple of cam recommendations were added to my previous post as an edit................