You only asked about the cable to the starter (pos). You should do the ground to the chassis too (neg). DC, everything grounds through the frame.

 

It is a circle and both need to be the same.....

 

I prefer welding cable. Lots of strands and very flexible.

 

Yea I was talking to a co-worker and he suggested the same. Welding cable. Thanx..

 

Yeah, I'm going to make a set up & found these on ebay:
http://www.ebay.com/itm/261070495836...ht_4609wt_1406

http://www.ebay.com/itm/191352434385...ht_6135wt_1362

http://www.ebay.com/itm/TEMCo-LUG-CR...ht_6665wt_1362

Of course you need to buy the crimping tool, but its not that much.
Of course if a couple went in & bought it and shared the cost, you could come out with not spending a whole lot of cash!

Ride Safe,
harold

 

HF has a hydraulic crimping tool. http://www.harborfreight.com/hydraul...ool-66150.html

 

Just a heads up that the link above for the cables is for 2/0 cable instead of 2 awg cable. The 2/0 is heavier than the 2 awg. Here's the link for the 2 awg cable.
http://www.ebay.com/itm/WELDING-CABL...item3cc99d2c09

 

Thanks for the heads up, Tony. I hope I didn't inconvenience anyone & apologize for wrong info. And I havent ordered the cable yet, Tony, so thanks again for the catch!

Ride Safe,
Harold

 

You're welcome Harold. 2/0 copper is used for 200 amp service entrance cable.