Ultima 127 problem
#1
Ultima 127 problem
Heading back from a couple hundred mile ride, 60 miles per hour, oil temp at 200, started to miss a bit, rode 3 miles to nearest town, pulled into station and could hear the sound, not a knock, almost like something rubbing, almost sounded like it was cooming from the right side, plenty of oil, plugs look good. pushrods? Will start it up tomorrow and try to find where it is comming from. Thanks in advance.
#3
#4
#6
Rubbing sound and a miss... sorta sounds like it "could" be a bad roller on a lifter. If they seize it'll make a scraping noise. If it's in the nose cone area, you would want to investigate before running it much at all. If that is the case, it'll wear out a cam pretty quick.
Admitidly, I have no Ultima experience, but assuming it's along the HD lines of design and it has fully adjustable pushrods, swapping a lifter(s) is no problem at all.
Admitidly, I have no Ultima experience, but assuming it's along the HD lines of design and it has fully adjustable pushrods, swapping a lifter(s) is no problem at all.
#7
With only 3000 miles, I am going to assume the motor is less than a year old. Call Midwest Motors and they will send you the replacement parts. Make sure to ask for the upgraded pushrods if you don't already have them. Midwest Motors took care of me when my lifters failed. No questions asked. Great company to deal with.
Last edited by TheGoat; 05-26-2009 at 06:20 AM.
Trending Topics
#8
127 problems
With only 3000 miles, I am going to assume the motor is less than a year old. Call Midwest Motors and they will send you the replacement parts. Make sure to ask for the upgraded pushrods if you don't already have them. Midwest Motors took care of me when my lifters failed. No questions asked. Great company to deal with.
Just got back from a shop, sounds like the noise, metal - metal ,is in the engine, something came loose somewhere, engine starts right up, seems to have good compression and does not smoke, but has the terrible noise. The will take a few thing off tomorrow to see if they can notice anything and put a stethascope to it, I am not allowing them to tear into it till I have a better idea of what I am looking at. Not a good time to spend a bunch of money on a engine w/3,500 miles on it. Maybe Ultima will help me out depending on what we find. Any advice would be appreciated. Choptop
#9
127 problems
Got to see the damage today. Rear exhaust lifter failed, clean break in the pin, he feels that it happened a while back and may possibly been feeding needle bearings into the return side of the oil pump for a while, cam is damaged ,oil pump is damaged, (2) push rods are bent. It is out of warranty but I only have 3,500 miles on it, this should not happen, will contact Ultima tomorrow to see if they will do anything. Any advice would be appreciated.
#10
Just got off the phone w/Matt at Ultima, warranty dept. I am told. Let him know what had happened, age of engine, miles on it and that I understood it was out of warranty but this should not happen and that I had heard on forums that they were fair and asked him what he could do. He said they will cover parts, I said thank you very much. Gave him the shops number and I imagine he will call and ask them to send the damaged parts in. Hope it all works out, labor will be enough as it is.