Problem with bike after exhaust install
#1
Problem with bike after exhaust install
I have a 2016 flhxs. I removed the factory air cleaner and installed the screaming eagle billet cut back black intake. Tested the bike after the install and it started. I then installed a thunder header 2 into 1 exhaust. After the exhaust install, the bike will not start and displays the oil light on the dash. it almost acts like the battery does not have enough juice to start the bike. Has anyone else ran into this issue or can anyone tell me the possible cause of the bike not starting? Any suggestions for where to begin trouble shooting? Any and all help is greatly appreciated.
#2
#3
Re trace your steps from the beginning of the install to the end, but broaden your scope to examine all of the other components in the surrounding area of your work-it sounds electrical, so I would keep an eye out for damaged/disconnected wiring.
I'm surprised, by some of the things I've missed while re-checking my work. Pinched wires, loose clamps, etc
I'm surprised, by some of the things I've missed while re-checking my work. Pinched wires, loose clamps, etc
Last edited by schlacker; 11-29-2015 at 05:52 AM.
#4
Thread
Thread Starter
Forum
Replies
Last Post