Zenith carb
#1
Zenith carb
Picked up a '75 Ironhead (why?) and have it dialed in so it starts right off, idles good, and responds very good to blipping the throttle (seems a little fat). The major issue is that if I don't shut off the gas it will leak all over the garage floor (not good when there's a pilot light in furnace). I've had it apart at least a dozen times and recently set the float level to almost closed. The problem comes in when trying to get that damn leather seal back into the accelerator pump. Its a bitch. That's where the fuel is leaking from. Man I've tried evrything to get this to stop. I know, buy a Super "E", but don't have thejing. Been a lean winter and I'll be damned if I'M GOING TO LET THIS SUMBITCH BEAT ME! Oh yeah , I got the overhaul kit for it and installed all that **** too. Help!
#2
RE: Zenith carb
We haved used a little grease on the leather to help it along.
It must face down also.
It must face down also.
__________________
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
Thread
Thread Starter
Forum
Replies
Last Post