2-1 versus 2-2
#2
RE: 2-1 versus 2-2
skeefer, you're going to hear a chorus of voices proclaiming that 2-2s suffer from low TQ at lower RPMs where you ride the most....and for the most part it's true. HOWEVER, I firmly believe that a properly matched 2-2 *stepped* header pipe does a fine job across the entire RPM spectrum. 2-2 pipes and low end TQ are NOT necessarily mutually exclusive.
#4
#5
RE: 2-1 versus 2-2
2-into-1 will typically make more power across the board. True Duals sound better (just my opinion). I run the D&D Fat Cat 2-into-1 and I love it. I think the Rinehart true duals have a better sound but I love the look of the D&D and the performance increase over stock.
---Chris
---Chris
#6
RE: 2-1 versus 2-2
Burns Stainless.
They will manufacture a collector, and then tell you exactly the size of the intial primary tube diameter, and how long, as well as the next step, and the next step, of the pipe size.
They have a work sheet you fill out with all aspects of the engine build. Not chrome plated, with tribal flames, or flashing lights, though.
They will manufacture a collector, and then tell you exactly the size of the intial primary tube diameter, and how long, as well as the next step, and the next step, of the pipe size.
They have a work sheet you fill out with all aspects of the engine build. Not chrome plated, with tribal flames, or flashing lights, though.
__________________
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
Thread
Thread Starter
Forum
Replies
Last Post
nate_dawgg
Engine Mechanical Topics
2
02-08-2015 05:59 PM