EVO Tappet Replacement
#1
EVO Tappet Replacement
I was told that my '91 FLHTC would need new tappets at 30k miles - I thought it was dealer propaganda. \\; But, now at 33k miles my bike is leaking oil &\\; it seems to be coming from the rear tappet block weep hole (most of the 33k miles were in Tokyo, so there are a lot more hours on the engine than the odometer would suggest). \\; Is it likely that the tappets need to be replaced, or maybe just the pushrods adjusted (we put in adjustable when we replaced the cam- okay, I had help on this). \\; Oil pressure is 20-25 psi (&\\; I haven't taken off the cooler cover). \\; Is there any other reason it would be leaking so much oil? \\; Is this something I can do myself (moderately mechanically inclined), or should it go to the dealer? \\; It doesn't seem too complicated, but you never know. \\; Are there any good step-by-step repair manuals (besides the H-D shop manual, which is starting to fall apart)? \\; Thanks.
#2
#3
#5
RE: EVO Tappet Replacement
Evo lifters ticking is not a uncommon issue, nor would a stock evo lifter failing be uncommom. The big axle version are much stonger and tend not to have as many issues. There are many manufactures of lifters with big axle I would spend the money on a good set. If you have noise it should be inspected for any issues. Most common are a bent or loose axle that will allow the needle bearings to fall out. The picture is of a engine that a customer took to a shop for ticking. They thought it was only a mis adjusted push rod, well they re adjusted the push rod and it caused lifter noise to go away... for a short time. The roller seized in the lifter body and spitting out needles, shearing the oil pump drive key, and wiping out the cam lobe int he process. Metal was through out the entire engine. That would be a worst case experiance. Many shops will say 25,000 miles in stock lifters and you should at least inspect them, however if you have them out why not just replace them with a quality unit and not worry about it any longer. In this picture the lifter that failed is a big axle, I do not know the manufacture of this lifter.
Last edited by HDWRENCH; 08-07-2008 at 02:48 PM.
Thread
Thread Starter
Forum
Replies
Last Post