New Wood WM8-22X cam for Milwaukee Eight engines w/ dyno charts
#1
New Wood WM8-22X cam for Milwaukee Eight engines w/ dyno charts
This week we tested a new cam from Bobby Wood we have been working on for stock compression M8 engines. This new cam will be available late November
2017 FLHTK 107" twin cooled, Wood WM8-22X cam, Stage 1 air cleaner, Jackpot head pipe & mufflers, Power Vision tune
5th gear run
vs stock bike (with slip ons) as recd. Tested same day. 5th gear runs
2017 FLHTK 107" twin cooled, Wood WM8-22X cam, Stage 1 air cleaner, Jackpot head pipe & mufflers, Power Vision tune
5th gear run
vs stock bike (with slip ons) as recd. Tested same day. 5th gear runs
__________________
Jamie Long / Fuel Moto USA
The USA's Leader V-Twin EFI & Performance www.fuelmotousa.com
Contact 920-423-3309
Email jamie@fuelmotousa.com
Jamie Long / Fuel Moto USA
The USA's Leader V-Twin EFI & Performance www.fuelmotousa.com
Contact 920-423-3309
Email jamie@fuelmotousa.com
#4
Wood Performance has M8 cams for the higher compression M8 engines as well. For the H-D Stage III and V kits we generally use the WM8-222 or WM8-777 and they are strong performers for sure.
#6
#7
Wood WM8-22X cams are now in stock and available. We are processing & shipping pre-orders today and new orders will start shipping tomorrow. https://www.fuelmotousa.com/series-221026
Trending Topics
#8
Wood WM8-22X cams are now in stock and available. We are processing & shipping pre-orders today and new orders will start shipping tomorrow. https://www.fuelmotousa.com/series-221026
#9
Installed the WM8-22X cam in a 2018 CVO Limited yesterday. This is a stock M8 117 bike with Jackpot M8 2/1/2 head pipe & S&S Grand National mufflers, and we tuned it with Dynojet Power Vision. Customer was looking for maximum low end torque, this combination delivered; it breaks 120Tq at 2200RPM and carries the torque strong. Peak numbers were 112Hp/130Tq
Thread
Thread Starter
Forum
Replies
Last Post
fuelmoto
Vendor For Sale Classifieds
0
10-19-2017 01:46 PM