Muffler packing source
#1
Muffler packing source
I recently pulled the baffles from my Rush slipons and the packing material was all but gone. A quick call to Rush and they told me that new packing would run me $20 plus shipping. I checked around and most other sources were in the $20 range plus shipping as well but you could get two repacks out of them. I found a place that carries the long strand muffler packing in 60" x 15" which will give me at least four repacks for $10 The shipping was $6 which is not bad. The site is Bristol Core dot com. They specialize in muffler packing materials for motorsports. I repacked the baffles and they sound good. I thought to throw this out there in case someone is contemplating a repack.
#2
another source:
http://www.ebay.com/itm/1-4-10-x-38-...item1e9bdafa3b
but I found the ceramic packing lasts much longer:
http://stores.ebay.com/Thermal-Solut...sub=8912838010
http://www.ebay.com/itm/1-4-10-x-38-...item1e9bdafa3b
but I found the ceramic packing lasts much longer:
http://stores.ebay.com/Thermal-Solut...sub=8912838010
Last edited by awilson40; 04-04-2015 at 01:29 PM.
#5
#7
Trending Topics
#8
#9
I've done mine twice in 51k but haven't had to repack my Rush muffs for 2-3 yrs.
Had mine since 07. Actually my set was the first Rush pipes that the dealer put on.
the last time they sent me 4 pieces of matting as they now say to Double wrap them with the seams 180* (opposite sides)on the baffles.
Also I just use plain ole 1 inch wide paper masking tape to hold the material on the baffle. 1 wrap on the ends and 1 in the middle.
http://www.interplas.com/product_ima...chx60Yards.jpg
.
Had mine since 07. Actually my set was the first Rush pipes that the dealer put on.
the last time they sent me 4 pieces of matting as they now say to Double wrap them with the seams 180* (opposite sides)on the baffles.
Also I just use plain ole 1 inch wide paper masking tape to hold the material on the baffle. 1 wrap on the ends and 1 in the middle.
http://www.interplas.com/product_ima...chx60Yards.jpg
.
Thread
Thread Starter
Forum
Replies
Last Post
RadRodriguez
Multi-Fit Parts and Accessories
0
01-15-2015 09:14 AM