A front turn signal mount busted on me and to replace it I have to remove the 3 wires from the connector. How do I do this. I have everything apart just cant figure out how to remove the 3 wires on the right. This needs done so the wires can slide through the mount bolt hole.

 

Cut them and then splice them?
I'm not sure there is a wire lock on that connector.

 

Do not cut them thats for amateurs. Buy the service manual, it explains how to remove in depth

 

You need this...Part #381-087
J&P Cycles, about 13 bucks.

 

Or use a paper clip or a small screw driver like the kind for glasses repair..you just need to release the clip.

 

Be sure you pay attention to which one goes where

 

Thanks everyone. No service manual or special too;. Used a flat head screwdriver from my laptop repair kit (I am an IT guy) to release the pins. now I am just waiting for the HD dealer to call me letting me know the part arrived