Hi Guys,
I am in need of help and/or advice. I did the console swap along with a speedometer swap and all went well fairly easy. No problems or issues during install but ever since the swap my Low Range fuel lights are on and yesterday it registered fuel levels and after it was off for the night, I got back on to ride again today but it is back to the same problem Low Range is displayed with flashing fuel light. What am I missing here? What could have gone wrong? Any help or suggestions would be highly appreciated. Thanks in advance.

 

Anyone have any idea??

 

back track your wiring, especially your ground wire

 

As previously mentioned start by checking your wiring - next I would fill the tank and run it till (almost) empty (you should have an base line of the milage you get out of a full tank) and then repeat to see if it clears the issue...wish I could be more assistance

 

new speedo takes a half tank of gas to get your mileage set if you went with a Harley speedo. The calibration guidelines are in the install instructions.