High hp fuel delivery ?'s
#1
High hp fuel delivery ?'s
Is it possible to starve the engine at high rpm on the dyno or drag strip if the fuel line dips below the bowl? I have a pingle hiflow and 5/16 or 3/8 fuel line. Im running a 180 main jet on a 45 mikuni. Im concerned about 6500 to 7500 rpm's. There is not enough room to run the carb inlet straight up. Thanks, Madnss
#2
I ask because Im running lean on the big end and fat as a pig in the middle. On a wide open pull the mikuni runs off of the main jet only. So, im not getting enough fuel or its the cams, pipe combo, reversion thing going on....im assuming.
Thread
Thread Starter
Forum
Replies
Last Post