Has anyone used Them for a cylinder boring? I'm running andrews 21 cams now I been thinking of going 95 inch and I know the andrews 21 don't need headwork but why there off I'm sure Street port would help

 

Most everyone, including other builders & head porters speak highly of them.

I've seen a couple dyno sheets of 95"s with the Andrews 21s & ported heads that made very respectable numbers & gobs of low end torque.

 

call and talk to Bean good guy.Let him know what you what to do.I know you posted on another forum about compression read my post. He will set the numbers for your build so you dont end up with mis matched ****. Theres builders all over these forums.Hes just one of them.

 

OK thanks