ECM Error codes
#1
ECM Error codes
P1356 P1475 P0641 P1511
Please help me. I have been gaining a lot of information on this forum. But have registered now. I have fitted a Power Vision to my 2013 HD Road King. I have done a few runs on auto tune and loaded it. i then downloaded a map from S&S and autotuned that. The problem now is that my bike as soon as I open the throttle it goes to a limping mode idle. I have restored my oem tune but the same happens only when i open it wider. I have taken it to the local HD dealer and they replaced my TBW as I previously installed longer handlebars and cut and soldered some wires. After the new wires the same tinh is happening.
I do not know what to do please help
Please help me. I have been gaining a lot of information on this forum. But have registered now. I have fitted a Power Vision to my 2013 HD Road King. I have done a few runs on auto tune and loaded it. i then downloaded a map from S&S and autotuned that. The problem now is that my bike as soon as I open the throttle it goes to a limping mode idle. I have restored my oem tune but the same happens only when i open it wider. I have taken it to the local HD dealer and they replaced my TBW as I previously installed longer handlebars and cut and soldered some wires. After the new wires the same tinh is happening.
I do not know what to do please help
Thread
Thread Starter
Forum
Replies
Last Post
CarlFitzwater
Ignition/Tuner/ECM/Fuel Injection
4
01-21-2018 11:26 AM