It looks like A triple clamp ground Part# 72364-06 . Wire size 10-14 gauge / cost .88 cents.

 

Spot on with that p/n that is excellent. I broke two out of four trying to disassemble the turn signals. You dont happen to know the p/n for the light socket crimp terminals on the violet and blue wires also do you?

 

Taillight at the 4 pin connector that has 3 wires in it. If so it part # 73191-96.

 

If not post A picture. And I'll try to find it.

 

Looking for the connector on the black wire that sockets up into the reflector, and also for the connectors on the blue and violet wires that contact the bulb.

Dealership tried really hard but they couldnt drill down into the diagram far enough to come up with a number.

 

Did you brake the piece that the wires went into. If so that is part #68497-07 Socket assy. with mount. HD don't sell the button contact. You might haft to go to parts store get a taillight socket with the same button in it / cut and solder it in.

 

Does the socket assembly kit that you referenced have the wires in it?

I mean...somebody manufactures these crimp connectors. I have a molex crimper...Just need the terminals

 

i was able to put it back together after powdercoating.
thanks everyone for all the help. appreciate it.

 

I'm still working on this, but not getting anywhere.

For the late model dyna, 68904-00 (front) and 68905-00 (rear) are the socket assemblies that have the wiring pigtail already in them. HD definitely does not sell the crimp connectors individually, and I'm not sure that a p/n exists for them.

That being said, I reiterate that these terminals are manufactured, somewhere. Because I broke a couple, it would be much easier to just re-strip the wire and crimp a new terminal on than to run a whole new socket assembly and route all the pigtail through the handlebars and all that. But it depends on being able to identify by correct name, and purchase these connectors.