Can anyone point me to install pics for Target Tune on a touring? Specifically, I'm most interested in the best way to route the front sensor lead and extension wire. I've seen at least one post say run it on the right side frame and one from Fuel Moto saying run under the tank. I'm not clear on the under the tank route but if Fuel Moto uses that route I'd be inclined to think that's the best method.

Since there are over 800 pages under the Power Vision sticky and I spent 2 hours looking without any luck I'm hoping someone who has already happened upon the same thing can point me in the right direction.

 

I ran it under tank, inside enclosure with bikes wiring harness

 

Thanks for that. Did you just zip tie the connection somewhere on the upper cross member of the frame or what? Trying to figure out what's best for that big connection from the O2 lead to the extension cable.

 

Yea, zip tied to the cross member.