Update...TTS VTune
#1
Update...TTS VTune
I just found out that TTS has a new upgrade for the VTune process. This new version will extend the VTune all the way to 100% provided you collected enough good data to allow it to happen.
So you guys run the updater for this new package. I'm reading the info on it now. It seems to now require Windows XP or higher.
So you guys run the updater for this new package. I'm reading the info on it now. It seems to now require Windows XP or higher.
Last edited by Mr. Wizard; 12-17-2010 at 06:37 PM.
#2
Well... here we go again... FYI to all you guys
Ver. 161 is now released for Mastertune and on their updater service. It was pointed out that in the “Save and Restore” area was only allowing com ports 1 – 12 while in the programming area allowed 1- 16. So this version, as of today, had that fixed so you now get 1- 16 in all areas. In the new download you will so get a displacement calculator in the “Tools” drop down.
Ver. 161 is now released for Mastertune and on their updater service. It was pointed out that in the “Save and Restore” area was only allowing com ports 1 – 12 while in the programming area allowed 1- 16. So this version, as of today, had that fixed so you now get 1- 16 in all areas. In the new download you will so get a displacement calculator in the “Tools” drop down.
#3
#4
You don't need to wait on the CD. Simply go to their website an download their "updater" an run it. It will install all of their software and calibrations so you can get a head start.
Thread
Thread Starter
Forum
Replies
Last Post