Hi all,

just starting to put a friends xl together. Frame and motor match as 74xl, but the wiring and other bits are 75 (maybe it was a late 74?).

the wiring was original but in a mess so I’ve stripped the loom to clean and check resistances.

the 3 breakers were cable tied onto the top tube under the front of the seat, but there are 3 breaker holders riveted on the flat strap at the end of the top tube (presumably the original location?).

the odd thing is that the wiring from the headlamp bucket plug and from the ignition switch are very slightly too short (but have original ring crimps).

where would the breakers normally be?

as usual, no fusible wire, but I’ll fit a 30A breaker at the battery.

here’s the start