kickstarter ratchet gear wont disengage
#1
kickstarter ratchet gear wont disengage
After replacing the clutch hub bearing noticed after re-intallation the kickstarter ratchet gear is not disengaging and its preventing the motor from turning a full revoulution. Anyone have the schematics how its supposrd to go on there?
Update: Issue resolved! Would delete thread but not sure how to do it. Ended up trying to put a rubber seal which created clearence issues.
Update: Issue resolved! Would delete thread but not sure how to do it. Ended up trying to put a rubber seal which created clearence issues.
Last edited by Ironkidzsled; 07-20-2014 at 12:25 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Jason LaRev
Primary/Transmission/Driveline/Clutch
2
10-16-2017 03:36 PM
floridaboston
General Harley Davidson Chat
0
08-09-2009 09:25 PM