Engine is 131 with about 1500 miles built by Gregg Dahl Gms Racing engines in Uniontown, Pa. Have all parts except rear fender to put bike back to stock


Engine:
Ported 110 Heads with bigger valves
Se 58MM Throttle body with bigger injectors
Se Air Cleaner
Millennium Jugs
Cp Pistons
Welded S&S Bottom End
10.7 Compression
Se260 Cams
D&D Boarzilla exhaust

Trans:
6 speed
Backcut by R&D
Barnett clutch with Billet Basket

Chassis:
Swing arm lengthen 6 inches (have stock swing arm)
Chain conversion (have stock belt an pulleys)


Electrical:
All ***** 1.4 Starter
dyna shift minder
dyna shift light
pingel kill switch
2 gauge battery cables

 

What are you asking for the bike?

Also, it's hard to tell from the pic, but does the seat sit on the fender or is there a big gap as a result of the longer swing arm?

 

Like to Get 19k....gap is not that bad u could get a custom seat made but its not a problem to ride 2 up as me an gf has made many couple hundred mile trips doin so

 

Bump to top