Outer cam bearing: Roller VS. Ball bearing
#1
Outer cam bearing: Roller VS. Ball bearing
Hope this is the right spot....I'm replacing outer cam bearing with the tensioner job. ( '02 88" TC - stock chain drive cam - carb) . Replaced inners and outer ball bearing cam bearings... was given ball bearing to replace roller bearing with? they're not HD bearings also. Is it OK to change from ball to roller? guy from company I bought from said they change because the ***** are tougher than roller?
Last edited by superderrick; 09-30-2014 at 02:50 PM.
#2
#3
Hope this is the right spot....I'm replacing outer cam bearing with the tensioner job. ( '02 88" TC - stock chain drive cam - carb) . Replaced inners and outer ball bearing cam bearings... was given ball bearing to replace roller bearing with? they're not HD bearings also. Is it OK to change from ball to roller? guy from company I bought from said they change because the ***** are tougher than roller?
Thread
Thread Starter
Forum
Replies
Last Post
superderrick
Engine Mechanical Topics
6
10-05-2014 10:38 AM