Trans locks up in 1st and 2nd
#1
Trans locks up in 1st and 2nd
99 Dyna. Just put this trans back together and testing it out by spinning shaft by hand it locks up in 1st and 2nd gear, 3-5 are fine. I took it back apart inspected all the gears and snap rings all are in correct place. Put back together as per manual same thing. I've done these many times before but never had this happen. Has anyone run into this before?
Last edited by customsoftail200; 02-08-2016 at 12:35 PM.
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
Ccr71
Primary/Transmission/Driveline/Clutch
4
04-11-2017 04:29 PM