Mark @ baker drivetrain

I would like to order the reverse gear for my harley touring roadking 2014, already installed Rinehart true dual (see pic.). Could you please advise what model should I use to fit in my case

 

I believe your bike came with a hydraulic clutch and you will want the front facing solenoid so the part number would be F6RV-HC. If you want the handlebar mounted switch housing as well the F6RV-HC-SH.

Thanks

Mark

 

Oh my bad, that pic only mentioned the exhause shaft, my bike is normal cable clutch type, could you plz give me the other option, sorry for any inconvenient may caught

 

If you have a cable clutch then the part number will be F6RV-MC-SH.

Thanks

Mark

 

Thanks. F6RV MC SH is the front facing solenoid or handle bar mount ?

 

That part number is both, the front facing solenoid with the handle bar mount. If you do not want the handle bar mount the the number will be just F6RV-MC.

Thanks

Mark

 

I had browsing the baker website, but could not found the part ???

 

Here you go:

http://bakerdrivetrain.com/f6r-factory-6-speed-reverse

 

Mark
Already ordered the full set and now waitting for the delivery for a couple of weeks. Thinking of assembly by myself cause my area no dealers has experience abt that, and now I have starting with prepare all the tools may needed. Read though the Baker's installation instructions then first of all my series questions is : do the Inner bearing race removal kit is required (it located in the main shaft), cause we have only change the Counter shaft and seem does not tough anything to the main shaft @the pulley side. We can pull all gearbox out and its doen't need to remove the Inner bearing Race. Pls advise and corrected me if I am wrong

 

The inner bearing race must be removed, the gear set is attached to the bearing door and must be removed from the case as a whole unit. Then the counter shaft can be removed from the bearing door. The gear set can not be removed with the inner primary race on the mainshaft it must be removed.