Today I order Andrews 48 cams,S&S adj push rods, new bearings and the Heartland bearing removal/install tool.
Im looking to get the gaskets and o rings necessary to get the job done. Im finding kits that have all gaskets and o rings that one would use if removing rocker boxes. Is the just a kit that has the o rings and cam cover gasket.
I see fuel moto has the complete kit with bearings $60 plus shipping, but wont use alot of the gaskets in the kit.
Thanks
Rich

 

Why don't you go to the dealership and pick up what you need?

 

^ you will need a clutch spring and primary gasket anyway. Stock spring will likely slip

 

I just picked up that stuff at the dealer for around 80 bucks.
SE clutch spring
Tappet block gaskets
Cam cover gasket
Fluid
3 o'rings and some exhaust gaskets

 

Thanks fellas
I got looking around Ronnie HD online semantics and figured out there is the cam cover gasket, and 3 o rings that Ill need so yes ill head to the dealer tomorrow and get what I need. The S&S push rods comes with the tappet blocks gasket.
I sent a email to Fuel moto asking for a new map. Im thinking by next weekend Ill have all the goodies to do the swap

 

maybe im not understanding what you need, but S&S has a great cam install kit that you can find on ebay that has the o rings, cam chest gasket and the better bearings for around $40 if i remember correctly. it has all you need without all the extra garbage just to do a cam swap.

 

Most of Harley's gaskets are better than the aftermarket ones in my experience.

 

See my post
https://www.hdforums.com/forum/showthread.php?t=740092&page=2&styleid=9

 

im pretty sure S&S has a handle on gaskets....and for much cheaper.