has anyone powder coated the triple trees on a breakout?
#1
#3
Hey man,not on a Breakout,but I just did this to my Softail.I just ended up R&R'ing the bottom bearing,and taping off the bottom of the post where the bearing seats.Threw the trees in the freezer for a day,heated the new bearing for a few minutes in my powder oven,and it dropped right on w/o even tapping it down.Easy peasy.Dont forget to cover the stem nut threads.
Last edited by Daddy454; 01-12-2015 at 02:11 PM.
#4
#5
Hey man,not on a Breakout,but I just did this to my Softail.I just ended up R&R'ing the bottom bearing,and taping off the bottom of the post where the bearing seats.Threw the trees in the freezer for a day,heated the new bearing for a few minutes in my powder oven,and it dropped right on w/o even tapping it down.Easy peasy.Dont forget to cover the stem nut threads.
You R&R'd it?
Last edited by Stone Cliff; 01-13-2015 at 01:21 AM.
#6
Thread
Thread Starter
Forum
Replies
Last Post