I ordered my xied's for my 07 Heritage Classic and I be dang if I know where these dang things plug in at. all I know it's between the ecm and o2 sensor but the senosr wires are routed to places of unkown, So if anyone here has done the install can I get any info as where these things plug in at? I sure hate to have take this bike completely apart just to plug in two wires.

Thanks in advance.

James

 

I have not installed them... but I always understood they plugged right into the O2 sensors, and the plug that you unplug from O2 sensors goes into other end of the XIED.


Where that wire from O2 sensor leads does not matter, you unplug it right at the sensor.

 

One is under the battery. Mine had a clip on this holding it in place on the bottom side of the battery holder. Use a small screw driver to push the clip though the hole then fish it up and out. The other is under the plastic cover above the regulator in the front.

 

One is under the battery. Mine had a clip holding the plug to the bottom side of the battery box. Use a small screw driver to push the clip though then you can fish it out the top. The other was under the plastic cover above the regulator in the front.

 

Oops sorrt double post. Dam iPhone.

 

Thanks poolguy you saved me a lot of time and frustration chasing down the end of the o2 wires.

James

 

Got the xied's installed today on my bike and my security light went out to boot. I guess taking the packing and adding 30 additional holes to the baffles in my SE pipes must have messed with the ecm too much. Again a big thanks to poolguy for providing info on where the plugs were on my bike. You saved me time and headache trying to trace the ends down. Now my next move is go ahead and install my stage 1 air cleaner kit and in a few weeks a different set of pipes.

James