Cable Length for 14" Apes?
#1
Cable Length for 14" Apes?
Bike- '06 NightTrain
What- Need cable length for 14" Evil Apes
I am finally pulling the trigger on swapping out my drag bars for 14" Evil Apes.
I called magnum shielding to order my cables thinking they would know what length I should get....they don't.
Does anyone know the +over stock length needed to swap out stock drag bars on a 2006 Night Train for 14" Carlini Evil Apes.
If not, anyone have any suggestions to help me figure this one out.
Thanks,
Scott
What- Need cable length for 14" Evil Apes
I am finally pulling the trigger on swapping out my drag bars for 14" Evil Apes.
I called magnum shielding to order my cables thinking they would know what length I should get....they don't.
Does anyone know the +over stock length needed to swap out stock drag bars on a 2006 Night Train for 14" Carlini Evil Apes.
If not, anyone have any suggestions to help me figure this one out.
Thanks,
Scott
#3
Check their website, you can enter ur model of bike and see what stock is, then figure out your + range. You got to factor your stock riser height though over a 1-1/2 or 2" riser, if I remember right.
Compare it to this: I will take 2" off my cables for 16" bars, and I got the stock short 1.5" or 2" riser, so for 14" apes on train with 1.5"or 2" riser, you should be close to this:
Clutch: 68-11/16"
Brake: 50"
Throttle & Idle: 37.5"
Wire extensions will be 12" by default, just cut and solder and be done with it.
Compare it to this: I will take 2" off my cables for 16" bars, and I got the stock short 1.5" or 2" riser, so for 14" apes on train with 1.5"or 2" riser, you should be close to this:
Clutch: 68-11/16"
Brake: 50"
Throttle & Idle: 37.5"
Wire extensions will be 12" by default, just cut and solder and be done with it.
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post