ironhead 1000 -7/16 thread --from 3/4
#1
03-02-2016, 10:44 PM
Join Date: Jun 2015
Location: ELDRED pA.
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
ironhead 1000 -7/16 thread --from 3/4
just purchased a denso dual tip for my 74 ironhead ---Not available with a 7/16 reach --soooo i just got a 14mm jam nut along with a copper washer ==7/16 reach ---turned the nut dia. down to plug dia. -the thickness of the n
ut is 3/8 -- the dual tip sticks out so with the copper washer all is fine
ut is 3/8 -- the dual tip sticks out so with the copper washer all is fine
Thread
Thread Starter
Forum
Replies
Last Post