Replacing rear turn signal with front
#1
#2
Not a Trivial Task... But, it ain't nearly Warm here in my part of the Rhubarb Patch... so We Gots Time!!!
#3
I was just concerned if it would be possible to use a dual filament turn signal that wouldnt function as a running light.
#4
Oh... Ithought you wanted both Running and Turns... Will Not be a Problem to Put dual filament Unit right on, and wire accordingly... [only use one of the two wires... the Larger Filament I believe] ... or If you have damaged single Filament Turn Signal Unit... the Bulb holder can be swapped...
The following users liked this post:
Raypat (03-01-2020)
#5
Oh... Ithought you wanted both Running and Turns... Will Not be a Problem to Put dual filament Unit right on, and wire accordingly... [only use one of the two wires... the Larger Filament I believe] ... or If you have damaged single Filament Turn Signal Unit... the Bulb holder can be swapped...
#6
Yes, you can. I did it on my 92. The only difference is the bulb socket--it has provisions for both filaments. I operate mine as added running lights. I ring terminal connected the running light wires to a stud and nut on a relay that is on with the ignition. The wire for the flashing filament is wired the same as it was before the swap. I used red lenses rather than amber.
The following users liked this post:
Raypat (03-02-2020)
Thread
Thread Starter
Forum
Replies
Last Post
malomj07
Electrical/Lighting/Alarm
4
05-20-2016 06:59 PM
BlockHead96
Ignition/Tuner/ECM/Fuel Injection
2
07-01-2008 04:05 PM